The exchange of tapers forum is for classic and personally developed tapers. The definition of classic tapers are those tapers that were developed by rodmakers that are no longer alive. Please understand that rod makers who have developed their tapers, and are active in the community, should not have their tapers cloned, or shared, without their permission, please refrain for asking for those tapers as it infringes on the maker.
It's been a while, for years actually that I'm thinking about building a spinning rod for pike. Eight feet, two or three piece for Rapala type wooden...
Thus is what I believe to be a unknown Union Hardware taper. What I don’t know about tapers could be a book. I am told it is a junkyard dog, but I I...
I have been requested to make a Heddon Featherweight blank for a 7.5 ft rod. My understanding is that it was designated as a 0 3/4f. Does anyone have...
I have an Orvis that is a 7 1/2 ft. 5 wt. and the writing on the rod indicates it's a Madison Adirondack. The model number on the tube is 89729.
I've...
I'd like to build a rod for a buddy. He built this beautiful cedar strip canoe and I'm thinking a nice bamboo rod would go well with it. He plans on...
I found a taper listing on hexrod for a Dickerson 801611. Does anyone have a rod or built this? When I was looking at the numbers at the tip ferrule...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum