Waara V-Block
Moderator: Titelines
Waara V-Block
#2Give Eric a call, he made several a few years back for a bamboo rod class has a few left (I think).
Coren's Rod and Reel (773)631-5202
Rob Hoffhines
Edited for ph# typo
Coren's Rod and Reel (773)631-5202
Rob Hoffhines
Edited for ph# typo
Last edited by RWHoffhines on 10/11/10 07:58, edited 1 time in total.
Waara V-Block
#6If that doesn't pan out, Board member Jimmy Chang made some and advertised them here a while back.
"It is better to tie one good fly in an hour than a dozen that would only be taken by a trout with a sense of humor"
Uncle Bill
Uncle Bill
Re: Waara V-Block
#7It pays to clean out your shop drawers. I found a few more Waara V blocks if anyone is interested. PM me if you would like one.
Here is a pic for those that have not seen one in action. PM or canebuilder@gmail.com
Here is a pic for those that have not seen one in action. PM or canebuilder@gmail.com
-
- Member
- Posts: 2
- Joined: 05/24/20 15:33
Re: Waara V-Block
#8While I am reasonably certain these are tough to come by, does anyone know where I may find one?
Many Thanks in advance and Hello as this is my first post and looking forward to learning here in the forum!
Many Thanks in advance and Hello as this is my first post and looking forward to learning here in the forum!
- canerodscom
- Bamboo Fanatic
- Posts: 2865
- Joined: 02/01/04 19:00
- SpringCreek
- Bamboo Fanatic
- Posts: 3211
- Joined: 02/24/07 19:00
- Location: Wildwood, MO
- Contact:
Re: Waara V-Block
#10Art LeClair also has them available.
Then as it was, then again it will be. Though the course may change sometimes, rivers always reach the sea. - Led Zeppelin, 10 Years Gone
http://www.splittingcane.com
http://www.splittingcane.com
-
- Sport
- Posts: 29
- Joined: 08/08/16 09:42
Re: Waara V-Block
#14I have plenty of these available. I have been supplying these to the rodmaking community for 15 years or more. Detailed instructions are included. Contact canebuilder@gmail.com
I made a video showing the tool in action at
https://youtu.be/3yDaUsiXVqg
Thanks,
James
I made a video showing the tool in action at
https://youtu.be/3yDaUsiXVqg
Thanks,
James