Dickerson 761510

The exchange of tapers forum is for classic and personally developed tapers. The definition of classic tapers are those tapers that were developed by rodmakers that are no longer alive. Please understand that rod makers who have developed their tapers, and are active in the community, should not have their tapers cloned, or shared, without their permission, please refrain for asking for those tapers as it infringes on the maker.

Moderator: pvansch1

Post Reply
j76Fish
Member
Posts: 2
Joined: 09/16/20 09:37

Dickerson 761510

#1

Post by j76Fish »

Hi Everyone
This is my last effort to hopefully find or someone share the dickerson 761510 3 piece rod taper measurements. I was hoping my next build will be a three piece rod and I am stuck or hooked to dickerson tapers. Anyone willing to point me in the right direction or help would be awesome or I will look at the 8' Dickerson taper. I have found measurements for that particular taper. Thank you

User avatar
henkverhaar
Master Guide
Posts: 539
Joined: 07/02/16 15:37

Re: Dickerson 761510

#2

Post by henkverhaar »

As far as I can see, RodDNADesigner has a Dickerson 761510...

PT48
Master Guide
Posts: 772
Joined: 02/19/13 22:26

Re: Dickerson 761510

#3

Post by PT48 »

So too does The Lovely Reed by Jack Howell.

j76Fish
Member
Posts: 2
Joined: 09/16/20 09:37

Re: Dickerson 761510

#4

Post by j76Fish »

Thank you so much, Pt48, I just ordered the lovely reed book today in hopes of finding the taper, so that makes buying the book that much better for me and I am sure I can learn something as well. I am not familiar with RodDNADesigner, but I will check that out as well. Huge thank you, my obsessive compulsive was kicking in on finding this.

User avatar
henkverhaar
Master Guide
Posts: 539
Joined: 07/02/16 15:37

Re: Dickerson 761510

#5

Post by henkverhaar »

It is also in the free version of the program - RodDNA. I wasn't sure if it was only in the commercial version, and I couldn't access my other machine yesterday, but it is in the database of both versions of the program...

Post Reply

Return to “Taper Exchange”