Fitting a rod to ferrules on hand.

The exchange of tapers forum is for classic and personally developed tapers. The definition of classic tapers are those tapers that were developed by rodmakers that are no longer alive. Please understand that rod makers who have developed their tapers, and are active in the community, should not have their tapers cloned, or shared, without their permission, please refrain for asking for those tapers as it infringes on the maker.

Moderator: pvansch1

Post Reply
sanderson
Guide
Posts: 345
Joined: 06/29/20 19:55

Fitting a rod to ferrules on hand.

#1

Post by sanderson »

I'm searching for a 3 pc. taper using a 16 and an 11 ss ferrule. Any board members who could share/suggest one to use?
Top
Livingstone
Master Guide
Posts: 518
Joined: 08/26/12 07:54
Location: Canada

Re: Fitting a rod to ferrules on hand.

#2

Post by Livingstone »

Dickerson made a couple, the 801611 and the 861611. I have cast the 8'and was a 6 wt. for me. Livingstone.
Top
sanderson
Guide
Posts: 345
Joined: 06/29/20 19:55

Re: Fitting a rod to ferrules on hand.

#3

Post by sanderson »

Livingstone wrote: ↑
06/21/21 07:19
 Dickerson made a couple, the 801611 and the 861611. I have cast the 8'and was a 6 wt. for me. Livingstone.
thanks, it's listed on Hexrod, I must have missed it.
Top
Post Reply

Return to “Taper Exchange”