This forum began as Clark's Classic Bamboo Rod Forum, founded by Clark Davis for all who share a passion for classic rods. The forum is now owned by Whitefish Press aka Dr. Todd Larson - banjo.
For those who don't use English as their primary language we now have a translator for your language of choice hosted by Google.
I've have two handle problems that I'm seeking advise on. My 1899 Shakespeare steelhead reel the handle will
not rotate,I'm contemplating buying a p-foot replacement knob to fix this problem, I also have a Stuart perfect reel that has no handle or for that
matter even a pin to install one on, just a hole in the winding plate , Any suggestion before I start making a shoulder bolt arrangement to fix this?
The 1899 may just have dirt accumulation preventing it from rotating -- and if so you might try applying Boeshield to it a couple of times a day for a few
days. It is a penetrating lubricant that might free up the handle. However, if the handle is swollen internally it might loosen it only slightly.
The Stuarts handle seems to be a weak point. Owners who still have the original handle have sometimes fixed them with a spot of epoxy. I would say proceed with
whatever fix you plan -- the $ value is not too great so you are not adversely affecting.
Good luck,
Dennis
Last Edited By: dennis 11/24/2009 16:44.
Edited 1 time.
I've also had trouble on a nice Bauer that the wooden handle didn't rotate when you operated the reel. Pain!!
After trying multiple times w/a penetrating oil I found the simple fix wasn't in the diameter swelling on the center pin. The dang thing was too long!
I took a piece of 100 grit sandpaper, tore off a sliver and inserted it between the end of the little handle and the metal ass'y. piece it was attached to
and spun the wooden handle against the rough paper for a few minutes.
Are you positive that the handle was too long and not that the spindle it rotated on was too short? Perhaps each part individually was within
tolerance, but the spindle was at the short end and the handle at the long end.
Just my opinions, as stated previously if one disagrees or thinks I'm FOS, then just ignore anything I have to say...
Are you positive that the handle was too long and not that the spindle it rotated on was too short? Perhaps each part individually was within
tolerance, but the spindle was at the short end and the handle at the long end.
DISCLAIMER:The views, and opinions, posted here are the sole responsibility of the poster. Negative comments, when directed at individuals, or other private
concerns, will not be tolerated, posters should treat this media no differently than any other media source, in other words, if you would not submit what you
are going to post in the newspaper, or a magazine, and sign your name as the author, kindly refrain from doing so here. The Classic Fly Rod Forum is not an
open air forum for vendor/maker complaints. If you seek resolution, it is recommended you talk to the vendor/maker. If you seek an audience, it is recommended you go elsewhere. The admin and the Moderators reserve the right to remove any items deemed inappropriate according to the rules of conduct prominently displayed on each forum. If you have any questions or concerns you are free to email us at
send email to the Classic Fly Rod
Forum
Posting to sell Domain names and the like, i.e. SPAM, is against YUKU Policy, if you post these types of posts here you will be banned from this board and YUKU
will more than likely ban you from the site entirely. Thank you..........